Using The Rechargeable Battery; Button Operation - Pulsar AXION KEY Mode D'emploi

COMPONENTS AND CONTROLS
1. Eyepiece dioptre adjustment ring
2. Down button
3. Menu button
4. Up/Zoom button
5. On/Calibration ON button
6. Lens focus ring
7. Lens cap
8. MicroUSB connector
9. Battery release button
LED indicator displaying current status of the device
LED Indicator Operating Mode
Device is powered on
Device on / battery charge <10%
For a better viewing experience, we recommend
that glass wearers fold back the edge of the
elastic eyeshade.

BUTTON OPERATION

Control Condition / Operating 1 short press
mechanism Mode
ON button Device is powered off Power on the device Device calibration Power on the device
Display off Turn on display
Device turned on, quick Device calibration
menu, main menu
Change magnification (Zoom)
Up/Zoom Device is powered on
button
Quick menu Increase parameter
Main menu Navigation up, right
Menu button Device is powered on Open quick menu
Quick menu Navigation up
Main menu Confirm value, enter menu options
Down button Device is powered on Operating modes
Quick menu Reduce parameter
Main menu Navigation down, left
6 5 4 3 2 1
Fig.
1
LED indicator
7 9 8
Next short press Long press
Device calibration Power off the device
Display off / device
powered off
PiP on/off
Increase parameter
Navigation up, right
Open main menu
Exit quick menu
Exit menu options, exit
main menu
Color palettes
Reduce parameter
Navigation down, left

USING THE RECHARGEABLE BATTERY

AXION KEY thermal imagers are supplied with a
rechargeable APS3 Lithium-ion Battery Pack. The
battery should be charged before first use.
Charging the battery
Option 1 (Fig.2) :
Install the battery (10) into its slot on the instrument
џ
case (14) by aligning the icons to form a 'dot' on the
device and the battery. (see Fig. 4).
Attach a USB cable (15) to the microUSB connector
џ
(8) on the device.
Connect the other end of the USB cable (15) to the
џ
mains charger (16) or to a USB socket connected to
another power source with rated output of 5V or less.
Connect the mains charger (16) to the mains power
џ
supply.
Note: The PB8I Power Bank may be used as a charger
(see Item 7).
Option 2 (Fig.3) :
Insert the rechargeable battery (10) supplied with
џ
your device, or purchased separately, fully along the
guide rail into the APS charger slot (аvailable
separately) (11).
Point A on the battery and Point B on the charger
џ
should be aligned.
Two batteries can be charged at the same time – a
џ
second slot is provided for this.
Attach the USB plug on the USB cable (15) to the USB
џ
connector on the mains device (16). Plug the
deviceinto a 100–240 V power outlet (17).
Attach the second plug of the microUSB cable to the
џ
socket (12) of the mains charger (11).
The LED indicator (13) will light up battery charge
џ
status (see table).
2