Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALL THE UNIT (
H
ORIZONTAL EXHAUST INSTALLATION ONLY
6. Reinstall and secure the faceplate to the unit using its
4 retaining screws (two per side, circled in FIG. 28). Plug
the blower cable to its connector on faceplate (FIG. 28).
CONNECT DUCTWORK
V
ERTICAL EXHAUST INSTALLATION ONLY
Ducted Installation
Use 6-in. round, 8-in. round (PM600SSV only) or
3¼" x 10" metal duct to connect the adapter damper on the
top of the unit to the ductwork above (FIG. 29, 8-in. round
not shown). Seal the joint using aluminum duct tape.
Non-Ducted Installation
A non-duct kit is required for this type of installation
(purchase separately, model number: HARKPM21).
To install, follow the instructions packed with the kit.
14
'
)
CONT
D
(
'
)
CONT
D
FIG. 28
FIG. 29
Publicité
Table des Matières
