Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WIRING
Note: This range hood must be properly
grounded. The unit should be installed by a
qualified electrician in accordance with all
applicable national and local electrical
codes.
1. Remove the wiring box cover. Remove a
knockout from the wiring box.
2. Feed 6" of power cable through the knock-
out opening and secure cable to the wiring
box with an appropriate connector.
3. Make electrical connections. Connect white
to white, black to black and green to green.
4. Replace wiring box cover and screws. Make
sure that wires are not pinched between
cover and box.
CONNECT DUCTWORK
1. Use 6" round metal duct to connect the duct
collar on the hood to the ductwork above (or
to the ductfree plenum for ductfree
configuration).
2. Use duct tape to make all joints secure and
air tight.
3. Slide the lower decorative flue section
downward, until it fits properly around hood.
4. Secure decorative flue to hood with screws
provided.
DUCTFREE FILTER
INSTALLATION
1. Purchase a ductfree filter kit (ROUND
FILTER) from your dealer.
2. Position the filters over the mounting
brackets on the blower inlet.
3. Rotate to lock filters in place.
6"
ROUND
METAL
DUCT
- 5 -
WIRING BOX
COVER
LOWER
DECORATIVE
FLUE
SECTION
DUCTFREE
FILTERS
Publicité
Table des Matières
