Warm Start Of The Engine; Stopping The Device; Trimming Techniques; Additional Safety Instructions - FUXTEC FX-PS152 Mode D'emploi

Original Bedienungsanleitung FUXTEC FX-PS152 / FX-PS162_de_en_fr_ita_rev06
NOTE: If the device does not start after repeated attempts, refer to troubleshooting
chapters.
NOTE: Always pull the starter cord straight out. Pulling the starter at an angle will cause
the rope to rub against the eyelet. Pulling the starter at an angle can cause the starter cable
to fray or break. Always hold the starter handle firmly when the rope is pulled back. Never
allow the rope to be thrown back from the pulled-out position. This could damage the
starter device.
30.

Warm start of the engine

Place the device on a firm and flat surface.
1.
2. Slide the engine stop switch down
3. Slide the choke to the "WARM START" position
4. Pull out the starter rope with a short-stroke until resistance is felt
(about 100mm). A continuous high-speed train will provide a strong spark and start the
engine
If the device does not start, please proceed again according to "Cold start of the engine
31.

Stopping the device

Unlock the throttle. Let the device return to neutral. Move the engine stop switch on the
handle upwards until the device stops. If it does not stop, pull out the spark plug connector
in an emergency. Never leave the device unattended while it is running.
32.

Trimming techniques

ADDITIONAL SAFETY INSTRUCTIONS

Before running your device, read notes in chapters 3 and 4 of this manual.
CAUTION
IF YOU are NOT familiar with the trimming techniques, practice with the DEVICE in the
"STOP" position (turned off).
ALWAYS TRIM OR CUT AT HIGH ENGINE SPEEDS. Do not run the device slowly at the start
or in trim mode.
ALWAYS MAKE DISTANCE IN THE WORKING AREA from cans, bottles, rocks, etc. Whirling
objects can cause serious injury to users or bystanders and damage the device. If an object
is accidentally knocked, immediately stop the DEVICE and check it. Never run the device
46