Lenze 9400 E94BSHE Série Instructions De Montage page 83

Safety instructions 3
General safety and application notes for Lenze controllers
Intended use
Drive controllers are components designed for the installation in electrical systems or
machinery. They must not be used as household appliances. They are intended exclusively
professional and commercial purposes according to EN 61000−3−2.
When controllers are installed into machines, commissioning (i.e. starting of the operation
as directed) is prohibited until it is proven that the machine complies with the regulations
of the EC Directive 2006/42/EC (Machinery Directive); EN 60204 must be observed.
Commissioning (i.e. starting of the operation as directed) is only allowed when there is
compliance with the EMC Directive (2014/30/EU).
The inverters meet the requirements of the Low−Voltage Directive 2014/35/EU. The
harmonised standard EN 61800−5−1 applies to the inverters.
The technical data and supply conditions can be obtained from the nameplate and the
documentation. They must be strictly observed.
The actuation of the inverters in specific areas in compliance with EN61800−3 (EMC
categories) possibly requires the use of filters.
Warning: in residential environments, this product may cause high−frequency
interferences which may make the implementation of interference suppression measures
necessary.
Transport, storage
Please observe the notes on transport, storage, and appropriate handling.
Observe the climatic conditions according to the technical data.
Installation
The controllers must be installed and cooled according to the instructions given in the
corresponding documentation.
The ambient air must not exceed degree of pollution 2 according to EN 61800−5−1.
Ensure proper handling and avoid mechanical stress. Do not bend any components and do
not change any insulation distances during transport or handling. Do not touch any
electronic components or contacts.
Controllers contain electrostatically sensitive components which can easily be damaged
by inappropriate handling. Do not damage or destroy any electrical component since doing
so might endanger your health!
Electrical connection
When working on live inverters, observe the applicable national regulations for the
prevention of accidents.
Carry out the electrical installation according to the relevant regulations (e. g. cable
cross−sections, fusing, connection to the PE conductor). Additional notes are included in
the documentation.
l
83
EDK94SH366 DE/EN/FR/ES/IT 7.0