Baxtran ABD Mode D'emploi page 35

7.2 CONFIGURATION OF THE LIMITS OF WEIGHT ( SUPERIOR AND LOWER) |
1. Press the key to access the parameter.
2. The display will show the message " 000.00L" ( inferior limit)
3. Use the keys and
4. Press the key to confirm.
5. The display will show the message "000.00h" (Superior limit=
6. Use the keys and
Note: You can can stay over the last digit to modify if you wish.
7. Press the Key to confirm.
8. El display shows the value.
DISPLAY VALUE
A 0
1
B 0
C 0
1
2
9. Press the keys and
10. Press the key to confirm.
7.3 AUTO SWITCH OFF |
MODES:
• AoFF 00 – Auto switch off deactivated
• AoFF 01 – Auto switch off activated in a minute. The scale is going to switch off automatically after 1 minute of not being used.
• You can configure the value wished from 1 to 99 minutes.
1. Press the key to have an access to the parameter.
2. Press the keys and
3. Press the key to confirm.
7.4 DISPLAY BACKLIGHTING |
MODES:
• A: Automatic.
• ON: Illumination Activated.
• OFF: Illumination Deactivated
1. Press the key to have an access to the parameter.
2. Press the key to select the desired mode.
3. Press the key to confirm.
to move the cursor and the key
to move the cursor and press the key
(configuration of the alarm)
ESTABILITY
There is no need to stabilize the alarm to make it ring
The alarm must be stabilized to ring
Always 0
Alarm switched off
The alarm ring if it is place on the band OK
( between the limits Lo and Hi)
The alarm rings if it is situated below the
inferior limit Lo or above the superior limit
Hi
to move the cursor and the key
UF-3
to move the cursor and the key
UF-4
to choose the desired number.
Hi
)
to choose the desired number.
A B C
0 0 0
LO LO OK OK
LO LO OK OK
to choose the desired number.
to choose the desired number.
USER'S MANUAL ABD
UF-2
HI HI
HI HI
EN EN
35