Crutch Holder; Pelvic Restraint Belt - Quickie Krypton R Notice D'utilisation

Crutch Holder

Crutch Holder
This device permits crutches to be transported directly on a
wheelchair. It has a Velcro loop to fasten crutches or other aids.
CAUTION!
Never try to use or even remove the crutches or other aids while
moving.
18

Pelvic Restraint Belt

DANGER!
Before using your wheelchair ensure the lap belt is worn.
•
The lap belt must be checked on a daily
•
basis to ensure it is free from any obstruction or adverse
•
wear.
Always make sure that the lap strap is correctly secured
•
and adjusted prior to use. If the strap is too loose it could
cause the user to slip down and risk suffocation or cause
serious injury.
The lap belt is fitted to the wheelchair as shown in the
illustrations. The seat belt comprises 2 halves. They are ftted
using the existing seat stay retaining bolt ftted through the
eyelet on the belt. The belt is routed under the rear of the side
panel. (Fig. 4.28)
Adjust the belt position so buckles are in the centre of the seat.
(Fig. 4.29)
Fig. 4.28
Adjust lap belt to suit the user's needs as follows:
To reduce the belt To increase the belt length
length
Feed free belt Feed free belt through slide adjusters
back through male and male buckle to provide more belt
buckle and slide length.
adjusters.
Ensure belt is not
looped at male
buckle.
When fastened check space between the pelvic restraint belt
and user. When correctly adjusted it should not be possible to
insert more than the flat of the hand between the lap belt and the
user. (Fig. 4.34)
Fig. 4.29
Krypton R Rev.1.0