Suzuki 57100-2884 Serie Instructions D'installation page 7

Installation of Grip Heater (L)
1. Remove the knuckle cover.
(if equipped)
(Refer to the DL650 service
manual)
2. Loosen the screw of balancer
with a + driver several turns
and pull the balancer assembly
out of the handlebars.
NOTE: Loosen the screw only
enough to remove the bal-
ancer. Otherwise, the bal-
ancer may disassemble
and some
may remain in the handle-
bar.
3. Open the gap between the grip
and the handlebar with a -
driver, then inject degreasing
agent to pull out the grip.
NOTICE
Use the - driver with care so
as not to scratch the surface
of the handlebar.
NOTE: Removed left side grip will
not be reused.
components
GENUINE SUZUKI ACCESSORIES
Knuckle cover Knuckle cover
Handlebar balancer Handlebar balancer
Screw Screw
7/17