Skil DL529301 Guide D'utilisation page 251

Using with a USB Device
(Fig . 4)
When a battery pack is installed,
place it on a surface to avoid
damage to the adapter during
operation.
a. Insert a battery pack into the
adapter.
b. Plug a USB cable (not included)
into one of the USB ports in the
adapter and plug the other end of the cable into your device.
c. Press the ON/OFF button to begin charging the USB device.
d. The USB device will fully charge.
e. After charging is completed, if left connected with the adapter,
it will automatically shut off after approximately 3 hours, and the
charging process will stop.
f. To reactivate the adapter, press the ON/OFF button.
g. When not using or after charging, remove the USB cable and
remove the adapter from the battery.
NOTICE:
The maximum current draw is 2.1A for each port and 3.6A total for
•
both ports.
If the device draws more than the rated output of the ports, the
•
adapter will shut off to protect the battery pack. To reactivate the
adapter, remove the device and press the ON/OFF button.
Charging time is dependent upon the device.
•
The adapter may warm with several continuous cycles; this is part
•
of its normal operation. Always use the adapter in a well-ventilated
area.
Fig. 4
USB Ports
15