Skil DL529301 Guide D'utilisation page 82

LED Light (Fig.10)
Your tool is equipped with a LED light,
located behind the upper guard. This provides
additional light on the saw blade and the
surface of the workpiece for operation in lower-
light areas.
The LED light will automatically turn on with a
slight squeeze on the trigger switch before the
tool starts running. It will turn off approximately
10 seconds after the trigger switch is released.
When the tool and/or battery pack becomes
overloaded or too hot, the internal sensors will
turn the tool off. If the tool and/or battery pack
are overloaded, the LED light will rapidly flash.
Rest the tool for a while or place the tool and
battery pack separately under air flow for cooling.
The LED light will flash more slowly to indicate that the battery pack is at low-battery capacity.
Recharge the battery pack.
18
Fig. 10
LED Light