Install Lock - Petsafe PPA11-14766 Manuel D'installation

Install Sliding Glass Pet Door with T-brackets without screws using the
3
adhesive
• Measure and cut the adhesive the length of the T-Brackets.
3H. Attach the adhesive to the T-Brackets. The adhesive should go
on the top of the "T" and on the inside of the "T" as shown.
Clean the adhesive contact areas thoroughly and then peel off
the release liner.
Attach the T-Bracket to the Sliding Glass Pet Door in the
desired location, similar to the first bullet point in Option 2.
Reinstall the Sliding Glass Pet Door into the track.
Step 4

Install Lock

Prior to installation and drilling, consult your sliding glass door manufacturer's
warranty. Unauthorized changes or modifications may void the warranty.
Installing screws into vinyl door frames or door jambs may crack the vinyl.
4A. Close the sliding glass door tightly against the Sliding
Glass Pet Door. Determine the location for each Latch at
a convenient height for you from the floor. A template is
provided. Keep the latch side of the template on the side of
the Sliding Glass Pet Door. Avoid the seam between the top
and the bottom. Tape the template in place and mark the
locations for the mounting screws. Remove template.
NOTE: Inspect location of screw marks to make sure they
will not be in contact with glass on either the sliding glass
door or the Sliding Glass Pet Door when drilling. If needed,
move the template over slightly and remark the screw holes.
Optional Adhesive (for use if not attaching the latches
with screws)
1. Attach the mounting plates to the back of the latch and keeper with the short
screws provided.
2. Measure and cut the adhesive the length of the latch and keeper.
3. Attach the adhesive to the latch and keeper.
4. Peel off the release liner.
5. Attach the latch and keeper to the Sliding Glass Pet Door in the desired location
www.petsafe.net
3H
4A
Sliding Glass
Pet Door
H
L A T C
P E R
K E E
Vertical Center
Line
9