Install The Boundary Wire - Petsafe in-ground fence HIG11-13555 Manuel D'utilisation Et De Dressage

Install the Boundary Wire

Step
7
To Bury the Boundary Wire
Burying the Boundary Wire is recommended to protect it and prevent disabling the system.
1. Cut a trench 1-3 inches deep along your planned boundary.
2. Place the Boundary Wire into the trench maintaining some slack to allow it to expand and contract with
temperature variations.
3. Use a blunt tool such as a wooden paint stick to push the Boundary Wire into the trench. Be careful not to
damage the Boundary Wire insulation.
To Attach the Boundary Wire to an Existing Fence
The Boundary Wire of the PetSafe
System can be attached to a chain link fence, split rail
fence, or a wooden privacy fence. The Boundary Wire
can be attached as high as needed. However, make
sure the Boundary Width is set at a high enough range
for the pet to receive the signal. If using a Double Loop
with an existing fence at least five feet tall, run the
Boundary Wire on top of the fence and return
it on the bottom of the fence to get the five foot
separation needed.
• Chain Link Fence (7A): Weave Boundary Wire
through the links or use plastic quick ties.
• Wooden Split Rail or Privacy Fence (7A): Use staples
to attach Boundary Wire. Avoid puncturing
the insulation of the Boundary Wire.
• Double Loop with an Existing Fence: Run the Boundary Wire on top of the fence and return it on the bottom
of the fence to get the five foot separation needed.
• Gate (Single Loop) (7B) : Bury the Boundary Wire in the ground across the gate opening.
Note: The signal is still active across the gate. Your pet cannot pass through an open gate.
• Gate (Double Loop) (7B): Bury both Boundary Wires across the gate opening while keeping
them at least 5 feet apart.
18
Before you begin installing the Boundary Wire, unplug the Fence Transmitter
power adapter from the outlet.
In-Ground Fence
®
1-800-732-2677
™
7A
WEAVE WIRE INTO FENCE
STAPLE WIRE TO FENCE
STAPLE WIRE
TO FENCE
7B
SINGLE LOOP
5' 5'
DOUBLE LOOP