Petsafe PPA11-14766 Manuel D'installation page 8

3E. Drill / " (2.5 mm) holes
7
64
through the sliding glass
door frame clearance
holes into the Sliding
Glass Pet Door.
3F. Fasten the Sliding Glass Pet
Door to the interior side of
sliding glass door frame
using four / " sheet metal
5
8
screws. DO NOT
OVERTIGHTEN.
Install Sliding Glass Pet Door with T-brackets using screws
2
• Slide the Sliding Glass Pet Door against the sliding door jamb. Measure and mark the top
center and bottom side of the Sliding Glass Pet Door where sliding door will close against.
Then mark on the sliding door frame (use a pencil or something that can be cleaned away).
These marks are for a marking guide only for the 2 T-brackets.
• Slide the panel over and up to be able to place the T-brackets into the track of sliding glass door.
3G. Take one of the T-brackets and place at the top of the sliding
glass track where the "T" part of the bracket aligns with your
mark. Mark with a pencil on the inside of the track for your pilot
holes and do the same for the bottom track. (The T-brackets are
universal and will work in the top or bottom track).
Use a / " (2.5 mm) drill bit to drill pilot holes for T-brackets
7
64
at the top and bottom of the Sliding Glass Pet Door. Place the
T-brackets back into place and, with the 4 mm x 10 mm sheet
metal screws provided, secure the T-brackets in the top and
the bottom of your sliding glass door track. Slide your Sliding
Glass Pet Door back against the door jamb and you will see
the T-brackets in front of your Sliding Glass Pet Door.
Use a / " (2.5 mm) drill bit to drill pilot holes through T-brackets and into the Sliding Glass
7
64
Pet Door at the top and bottom. Attach the brackets with the screws provided.
8
3E
1-800-732-2677
3F
3G