Thermal Disinfection - Grohe DESIGN + ENGINEERING 36 407 Notice D'utilisation

Thermal disinfection


Runtime of thermal disinfection
>
4 min
d/s d  d/s d
23 min
d
Set value.
Z
Factory setting: 4 min
^d Zd ^dKW
Start/stop thermal disinfection
Turn the mixer lever or thermostat to the hot water stop.
^ E
The command is transferred to the fitting immediately.
Point remote control at the sensor system.
Start thermal disinfection.
^d Zd
The status indicator shows whether the data transfer was
successful. The fitting starts thermal disinfection.
Stop thermal disinfection before the end of the runtime in
^dKW
the setting.
The status indicator shows whether the data transfer was
successful. The fitting stops thermal disinfection.
95