Subaru H001SVC100 Instructions D'installation page 5

7
PRE-ARRANGED JUMPER HARNESS CONNECTIONS
1. Locate the vehicle's 12-pin and 8-pin pre-fi t connectors
that were secured to the vehicle's wire harness with
breakaway tape near the upper passenger's side glove
box area. (FIGURE L)
2. Plug the remote engine start pre-arranged jumper
harness 12-pin and 8-pin connectors into the
corresponding pre-fi t connectors. (FIGURE M)
3. Secure the excess pre-arranged wire harness and
2-pin power window interrupt pre-fi t connectors to the
vehicle's wire harness using two (2) of the supplied
39cm tie wraps. Trim off the excess tie wraps.
(FIGURE N)
Secure the remote engine start pre-arranged jumper
harness to the vehicle's wire harness using one (1) of
the supplied 39cm tie wraps. Trim off the excess tie
wrap. (FIGURE N)
NOTE: Do not place tie wrap around "CAUTION:
DO NOT BEND" area of the pre-arranged jumper
harness, if applicable.
PART NUMBER ISSUE
H001SVC100/300
DATE
- 27 Aug 2021
FIGURE L
FIGURE M
FIGURE N
SUBARU OF AMERICA
5 OF 10