Subaru H001SVC100 Instructions D'installation page 3

5
REMOTE ENGINE START ECU MOUNTING
1. Locate the glove box inner cover. Using alcohol, clean
the back side of the glove box inner cover, as shown.
(FIGURE F)
2. Locate the remote engine start ECU. Remove the three
(3) small release liners from the ECU double sided tape
and attach the remote engine start ECU to the glove
box inner cover. Ensure the ECU is positioned against
the vertical character line and fl at against the multi-level
inner cover. Press fi rmly in place for at least 30 seconds.
(FIGURE G)
NOTE: Ensure the ECU connectors will be facing
toward the passenger's side of the vehicle when the
inner cover is replaced.
3. Using one (1) of the supplied 39cm tie wraps, secure the
remote engine start ECU to the glove box inner cover.
Trim off the excess tie wrap. (FIGURE H)
PART NUMBER ISSUE
H001SVC100/300
DATE
- 27 Aug 2021
FIGURE F
Vertical
Character
Line
FIGURE G
FIGURE H
SUBARU OF AMERICA
Clean with
Alcohol
3 OF 10