R&G LP0193BK Mode D'emploi page 7


Bring the whole assembly towards the rear sub-frame of the bike (coming from below as
illustrated on the first page of this manual). Feed all the wires through the initial hole on
the left hand side of the OEM undertray (arrowed in Picture 13). Support the assembly
onto the sub-frame at this stage and be aware of trapped wires. Please make sure that
Page | 7
there is enough slack within the wires as they can get damaged under tension.

Mount the base cover plate (Item 6) below the licence plate bracket assembly (Item 7)
with its catch inserted into the centre hole located on the OEM undertray unit (Labelled A
in picture 13 and arrowed in picture 14)

Insert the two M6 x 15mm bolts (Item 2) with M6 washers (Item 3) through the two holes
located on the back of the subframe (Arrowed in picture 15). Secure the assembly with
M6 washer (Item 3) and M6 nyloc nut (Item 8) on each bolt. Do not fully tighten the nuts
at this stage. Please make sure that the wiring is positioned in the same orientation as
shown in picture 15.

Insert the two Spacers (Item 4) between the sub-frame and the licence plate bracket
assembly as orientated in picture 16. Insert an M6 x 50mm bolt (Item 1) with M6 washer
(Item 3) through the hole where the spacer is aligned to on the sub-frame. Ensure the bolt
is gone through the spacer and the spacer is sandwiched between the sub-frame and the
licence plate bracket (item 7). Secure the assembly with M6 washer (Item 3) and M6
nyloc nut (Item 8). Repeat the procedure for the other M6 x 50mm bolt (Item 1).

Locate the wiring in the centre between the two spacers as shown in picture 16.

Tighten the four nyloc nuts using suitable tools to ±15 Nm (Picture 17)

Reconnect all the indicator wiring plug sockets and check operation (if illumination fails,
swap the bullet connections around).

Connect the tail light resistor (Item 19) to the tail light connector (Item 13) in this
scheme:

Connect the male connector of the tail light connector (Item 13) into the OEM female
connector in the main wiring loom.

OEM number plate connector light is no longer in use as the tail light unit (Item 12)
comes with built-in LED license plate lights.

Fit licence plate to the new licence plate bracket (item 7) (it may require re-drilling).

IMPORTANT: IF FITTING A FULL-SIZE LICENCE PLATE AND PLACING IT
FAR DOWN ON THE LICENCE PLATE HANGER, THERE IS A SMALL
CHANCE OF THE LICENCE PLATE HITTING THE BACK WHEEL UNDER
HEAVY LOAD AND OVER LARGE BUMPS IN THE ROAD. IT IS YOUR
RESPONSIBILITY TO CHECK FOR THIS POSSIBILITY AND TAKE
AVOIDING ACTION. FAILURE TO CHECK THIS COULD RESULT IN
SERIOUS INJURY.

Refit the Seat lock mechanism, tool holder and seat catch as original.

Refit seat.

Depending on local laws, attach enclosed red reflector (item 18) in an appropriate
location.

Please test the indicators, rear light, no. plate light and brake light before riding.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
RESISTOR BLACK---------------- BLACK (TAIL LIGHT)
RESISTOR BLUE ------------ CONNECTOR YELLOW
RESISTOR YELLOW ------- CONNECTOR BLUE
RESISTOR BLACK ---------- CONNECTOR BLACK
GENERAL TORQUE SETTINGS
R&G Racing
www.rg-racing.com
7
LP0193
Email: info@rg-racing.com