Assembly And Set -Up - Razor POCKET MOD Mode D'emploi

ASSEMBLY AND SET -UP

Turn power switch off before conducting any maintenance procedures.
Attaching the Handlebars
Tool Required: 6 mm Allen wrench.
Steering Bolt
1
Using a 6 mm Allen wrench, loosen steering bolt in four (4) complete turns
so that the wedge is loose and not touching steering tube.
3a
While inserting the steering
tube down into the handlebar tube,
hold steering bolt steady with
thumb and rotate handle bars 180
degrees to the left.
Steering Bolt
5
Securely tighten bolt using 6 mm
Allen wrench.
Wedge
3b
The throttle should now be
on your left and the lever brake on
your right.
2
Facing the front of the Pocket Mod,
position the handlebars so the throttle
is on your right and the lever brake
is on your left (the red "SAFE ZONE"
print will be facing you). Align wedge
inside handlebar tube. Note: Plastic
cover needs to be removed prior to
installing the handlebars.
Safety Zone
4
Slowly slide the handle bars up
to make certain that the bar is in the
"SAFETY ZONE". Failure to secure
the handlebars within the safety
zone can cause the handlebars to
come out while riding.
3
Note: Make sure the brake cables/
wires are out of the way before
inserting the handlebar into the fork.
WARNING: Periodically
check to make sure the steering bolt
is tightly fastened.
Note: Failure to secure the
handlebars within the safety zone
can cause the handlebars to come
out while riding.