Assembly Instructions; Attaching The Handlebar - Razor RDS Guide D'utilisation

ASSEMBLY INSTRUCTIONS

q Attaching the Handlebar
Tools Required: 5 mm Allen Wrench
1
Using a 5 mm Allen wrench,
loosen the bolts on the collar
clamp and slide clamp upward
on the handlebar. With a
twisting motion, push the
handlebar onto the fork until it
bottoms out on the fork headset
lock nut.
q Inflating Tires
The tires are inflated when shipped, but they invariably may lose some pressure between the point of manufacturing
and your purchase. Always inflate tires to the correct PSI before first time use.
2
With the front wheel pointed
straight ahead, the handlebars
square to the front wheel and
the Razor logo facing the front,
tighten the clamp as shown.
Alternately tighten each bolt
until securely tightened.
1
Using a bicycle-style tire
pump equipped for a Schrader-
type valve, inflate the tires to
the correct PSI indicated on the
sidewall of the tire.
3
WARNING: Failure to
properly install and tighten the
clamp may cause the rider to lose
control and fall. If you are having
difficulty understanding these
instructions, please contact Razor
Customer Service for assistance.
WARNING: Inflate the
tires to the recommended pressure
(60 PSI) before riding. Do not exceed
the tires' PSI rating. Over inflation
will cause a rupture and under
inflation may cause additional wear
on the tire.