R&G LP0186BK Mode D'emploi page 8

Picture 33
Picture 35
FITTING INSTRUCTIONS

To fit the R&G tail tidy, remove the pillion seat by removing the bolt as shown in picture 1.

Remove the bolt that secures the seat in place along with the bracket for the pillion seat, as shown
in picture 2.

Remove the seat as shown in picture 3.

Remove the two bolts that secure the plastic cover in place on both sides of the bike, as arrowed in
picture 4.

With these panels off, access can be gained to the two bolts that secure the inner plastic in place, as
arrowed in picture 5. Remove these two bolts, then slide the plastic panel forwards and remove
from the bike. Repeat this on both sides of the bike.

With these panels off, remove the two 12mm hex head bolts that secure the mounting plate in place
and remove from the bike, as shown in picture 6. Repeat this on the other side of the bike.

Remove the two bolts that secure the mudguard in place at the front, as arrowed in picture 7.

At the bottom front edge of the mudguard, there is a push rivet locating the part. Remove this push
rivet on both sides of the bike, as shown in picture 8.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
R&G Racing
www.rg-racing.com Email:
Picture 34
Picture 36
info@rg-racing.com