Use the cable ties supplied to neatly route the tail light and indicator wiring to the tail tidy bracket
via the two slots, as shown in picture 26.
The tail tidy assembly can now be fitted to the bike. To do this, re-use the two M6 bolts and bolt
the sides of the tail tidy to the mounting holes on the motorcycle frame on both sides, as shown in
picture 27.
Take the M8 x 12mm long button head bolt (item 4) and fit it through the remaining central
mounting hole on the tail tidy and tighten into the threaded hole on the motorcycle, as shown in
picture 28.
To connect the new tail light to the main loom, the wires need to be "cut and shut". To do this, cut
the connector and a suitable length of wiring (as shown in picture 29) off the OEM light and fit
bullet connectors to all three of the wires. Fit the opposite connectors to the tail light wiring and
connect the wiring as follows: OEM red to yellow, OEM blue to red & OEM black/yellow to
black.
Reconnect all three connectors to the main loom on the bike and check for the correct operation of
all lights at this stage (please note that the fourth connector (arrowed in picture 30) is no longer
required in use).
The rear mudguard can now be re-fitted to the bike using the reverse steps of how it was removed.
Re-fit the mudguard, push rivets and two bolts as shown in pictures 31, 32 & 33.
Re-fit the metal plates on both sides of the bike using the two bolts, as shown in picture 34.
Re-fit the two plastic side panels on both sides of the bike using the original bolts, as shown in
picture 35.
Re-fit the two plastic cover panels on both sides of the bike using the original bolts, as shown in
picture 36.
Re-fit the seat and pillion seat using the original bolts.
Ensure the tail tidy is securely mounted and all bolts are fully tightened.
Re-fit the licence plate (it may require drilling).
Depending on local laws, attach enclosed reflector in an appropriate location.
Test the license plate illuminator and all lights before riding.
Digital copies of these instructions are available to download from
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
ISSUE 1 08/10/2015 (AR)
R&G Racing
www.rg-racing.com
www.rg-racing.com
Email:
info@rg-racing.com