DeFelsko PosiTector SPG Manuel D'instructions page 4

Press the button or swipe right to return to a previous screen.
Select Exit to close the Menu.
When powered-up, the PosiTector automatically
determines which probe is attached and does a self-
check.
To disconnect a probe from a body, slide the plastic
probe connector horizontally (in the direction of the
arrow) away from the body. Reverse these steps to
attach a different probe. It is not necessary to power-
down the Gage when switching probes.
PosiTector SPG and SPG S probes include a 60˚ (ASTM D 4417
B) or 30˚ (Australian Standard AS 3894.5) angle tip (50 µm/2 mil
radius) with a measurement range of 0 to 500 µm (20 mils).
PosiTector SPG OS probes have the same specifications as the
PosiTector SPG probes above but feature a V-groove sleeve ideal
for measuring flat or convex surfaces such as tanks and pipes.
PosiTector SPG CS probes measure the profile of textured
coatings up to 1500 µm (60 mils) with a 500 µm (20 mil) radius 60˚
angle tip.
PosiTector SPG TS probes measure concrete surface profile up
to 6 mm (250 mils) with a 500 µm (20 mil) radius 60˚ angle tip.
When a Menu option is highlighted, the
icon indicates on-gage help is available.
Press or touch the
help. A formatted PDF containing all on-
gage help items is available at
www.defelsko.com/help
NOTE:
Update your gage to ensure that you
have the latest on-gage help information.
indicates that a sub-menu exists for the
Menu option. Select the option to display its
sub-menu.
Probes
2
icon to display the