Troubleshooting - Whirlpool WEE510SAGW Instructions D'utilisation

Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
Operation
PROBLEM
Nothing will operate
Cooktop will not operate
Excessive heat around
cookware on cooktop
Cooktop cooking results not
what expected
Cooktop element cycles on
and off on High setting
Oven will not operate
Cannot turn control lock on/
off
Oven temperature too high or
too low
Oven indicator lights flash
Display shows messages
Self-Cleaning cycle will not
operate

TROUBLESHOOTING

POSSIBLE CAUSES
Power supply cord is unplugged.
Household fuse is blown or a
circuit breaker is tripped.
The control displays an F9 or F9
E0 error code.
The control knob is set incorrectly. Push in knob before turning to a setting.
On ceramic glass models, the
oven Control Lockout is set.
Cookware that is not the proper
size.
Control knob set to incorrect
heat level.
Range is not level.
Element cycling due to a
temperature limiter.
Delay Start is set.
Control lock is ON.
Control is in Demo mode.
Electronic oven control set
incorrectly.
Hot Surface indicator light is ON.
Oven temperature needs
adjustment.
Power to range is turned on or
restored.
Power failure. (Display shows
flashing time.)
Error code. (Display shows letter
followed by number.)
Start needs to be pressed so a
cycle can begin.
The oven door is not closed.
The Self-Cleaning function has
not been entered correctly.
A Timed Cooking function has
been entered.
The range is in Sabbath mode.
SOLUTIONS
Plug into a grounded outlet.
Replace the fuse or reset the circuit breaker. If the problem
continues, call an electrician.
The electrical outlet in the home may be miswired. Contact a
qualified electrician to verify the electrical supply.
See the "Control Lock" keypad feature in the "Feature Guide."
Use cookware about the same size as the surface cooking area,
element, or surface burner. Cookware should not extend more
than 1/2" (1.3 cm) outside the cooking area.
See the "Cooktop Use" section.
Level the range. See the Installation Instructions.
This is normal operation. The element may cycle on and off to
keep the cooktop from overheating.
See the "Electronic Oven Controls" section.
Press and hold CONTROL LOCK for 3 seconds to unlock.
Demo mode will deactivate all oven elements. See "Demo
Mode" in the Electronic Oven Controls" section.
See "Electronic Oven Controls" section.
Wait for the cooktop surface to cool and try again when the Hot
Surface indicator light turns off.
See the "Oven Temperature Control" in the "Electronic Oven
Controls" section.
See "Control Display" in the "Electronic Oven Controls" section.
If the indicator light(s) keep flashing, call for service. See the
"Warranty" for more information.
Clear the display. On some models, reset the clock, if needed.
See "Clock" keypad feature in the "Feature Guide" section.
Depending on your model, press CANCEL to clear the display.
See "Control Display" in the "Electronic Oven Controls" section.
If it reappears, call for service. See the "Warranty" for more
information.
See the "Start" keypad feature in the "Feature Guide" section.
Make sure the oven door is fully closed.
See the "Self-Cleaning Cycle" section.
See the "Cook Time" section.
See the "Sabbath Mode" section.
15