Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
UR007G
► 1. Hex wrench
Correct combination of the cutting
tool and the protector
CAUTION:
Always use the correct combi-
nation of cutting tool and the protector. A wrong
combination may not protect you from the cutting tool,
flying debris, and stones. It can also affect the bal-
ance of the tool and result in an injury.
Cutting tool
Cutter blade
(2-tooth, 3-tooth, 4-tooth
blades)
Nylon cutting head
For cutter blade
Attach the protector to the clamp using bolts.
1
► 1. Clamp 2. Protector
For nylon cutting head
Attach the protector to the clamp using bolts. After
that, install the protector extension. Insert the protector
extension to the protector and then snap the clips on.
Make sure that the tabs on the protector extension fit
into the slots on the protector.
Protector
► 1. Protector 2. Clip 3. Protector extension 4. Cutter
14 ENGLISH
Installing the protector
WARNING:
Never use the tool without the
guard or with the guard improperly installed.
Failure to do so can cause serious personal injury.
NOTE: The type of the protector supplied as the stan-
dard accessory varies depending on the countries.
2
CAUTION:
Take care not to injure yourself on
the cutter for cutting the nylon cord.
1
2
3
5. Slot 6. Tab
1
5
4
6
Publicité
Table des Matières
