R&G LP0225BK Instructions page 5


Feed the licence plate illuminator wires through one of the heat-shrink tube (item 11)
provided and using a suitable heat resource, shrink the tube to protect the wires.

If using OEM indicators, fit both indicators onto indicator mount on the licence plate
Page | 5
bracket as shown in Picture 6 and secure using OEM washer and nuts removed earlier.

From the kit, take the three cable clips (Item 13) and attach them in-line onto the
underside of the licence plate bracket as shown in Picture 7.

From the kit take the cover plate (Item 2) and Rubber bung (Item 7), Place the Licence
plate bracket (Item 3) assembly onto the cover plate (Item 2), align all the mounting holes
as shown in Picture 8. Insert the Rubber bung (Item 7) through the large centre holes on
both licence plate bracket and the cover plate. The rubber bung will hold the two plates
together.

If using R&G mini indicators, take the two small rubber grommets (Item 4) and place
them to the smaller holes of the indicator mounts. Place R&G mini indicator onto the
larger hole of the indicator mount and secure with the nut provided. Feed both indicator
wires through a tube of heat-shrink and shrink it using appropriate heat resource. Repeat
the procedure for the other indicator.

From the kit, take the licence plate illuminator and indicator connectors (Item 10) and
connect the bullet connectors in this scheme:

Feed all the wires through the Rubber bung (Item 7) fitted earlier (as shown in picture 9)
and clip-in all the wires to the cable clips (Item 13) fitted earlier on the underside of the
licence plate bracket as shown in picture 10.

From the kit take the four spacers (Item 1) provided. Place the spacers on top of the four
mounting points on the licence plate bracket assembly with the counter-bore sits against
the cover plate as shown in picture 11.

Offer the whole assembly towards the sub-frame of the motorcycle and secure using the
four button head bolts (Item 9) and washers (Item 8) as shown in picture 12. Tighten the
bolts to an appropriate torque setting.

Please ensure the assembly accuracy of the fitted components are the same as exploded
diagram shown in page 1.

Connect the licence plate & indicator connectors to the main loom as original.

Tidy all the wiring using cable ties provided.

Check all the lights for correct operations.

Fit a licence plate to new licence plate bracket (it may require re-drilling).
IMPORTANT: WHEN FITTING A LICENCE PLATE (NO MORE THAN 130mm
TALL) IT MUST BE PLACED AS HIGH AS POSSIBLE ON THE LICENCE
PLATE HANGER AND CHECKED FOR COLLISION WITH THE REAR
WHEEL WHEN THE SUSPENSION IS AT FULL COMPRESSION, THERE IS A
SMALL CHANCE OF THE LICENCE PLATE HITTING THE BACK WHEEL
UNDER HEAVY LOAD AND OVER LARGE BUMPS IN THE ROAD. IT IS
YOUR RESPONSIBILITY TO CHECK FOR THIS POSSIBILITY AND TAKE
AVOIDING ACTION. FAILURE TO CHECK THIS COULD RESULT IN
SERIOUS INJURY.
Unit 1, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
Tel: +44 (0)1420 89007 Fax: +44 (0)1420 87301
o
Licence plate illuminator, Illuminator RED -------- Connector BROWN
o
Indicator, Indicator YELLOW----- Connector BROWN
Indicator BLACK ------- Connector BLACK
If lights fail to illuminate, please swap the connectors around.
R&G Racing
Illuminator BLACK ---- Connector BLACK
www.rg-racing.com Email:
5
LP0225
info@rg-racing.com