Recommended Cutting Equipment For Canada; Bar And Chain Combinations, Model 336; Saw Chain Filing And File Gauges - Gardena 336 Manuel D'utilisation

RECOMMENDED CUTTING EQUIPMENT FOR CANADA

The following is a list of recommended cutting equipment for Class 1A and 1B Chainsaws. The combinations of powerhead, bar
and chain meet all requirements outlined in the CSA Z62.1-95 Chainsaws and Z62.3-96 Chainsaw Kickback standards.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the corresponding
maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list. For guide
bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of sprocket teeth may be
considered to have equivalent kickback energy.
A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent or less
kickback energy than the sprocket-nose bar.
We recommend that you as replacement use the listed bars and chains or "Type C Low-Kickback Saw Chains" which are available
at your dealer.

Bar and chain combinations, model 336

The following combinations are CE approved.
Length, inch Pitch, inch
13 0,325
15 0,325
16 0,325
Saw chain filing and file gauges
TECHNICAL DATA
Bar
Gauge, inch Max. nose radius
1,3 10T
1,3 10T
1,3 10T
Chain
Type Drive link count
Husqvarna H30 56
64
66
– 37
Canadian