Key To Symbols; Symbols On The Machine; Symbols In The Operator's Manual - Gardena 336 Manuel D'utilisation

Symbols on the mac hine:
W ARNING! Chain saws can be dangerous!
Careless or improper use can result in
serious or fatal injury to the operator or
others.
Please read the operator's manual carefully
and make sure you understand the
instructions before using the machine.
Always wear:
• Approved protective helmet
• Approved hearing protection
• Protective goggles or a visor
Both of the operator ' s hands must be used to
operate the chain saw.
Never operate a chain saw holding it with one
hand only.
Never let the guide bar tip come in contact
with any object.
Tip contact may cause the guide bar to move
suddenly upward and backward (so-called
kickback), which may cause serious injury.
WARNING! Kickback may occur when the
nose or tip of the guide bar touches an object,
and cause a lightning fast reverse reaction,
kicking the guide bar up and towards the
operator. May cause serious personal injury.
Recommended cutting
equipment in this example:
- Bar length 16 inches
- Max. nose radius 10 Teeth
- Chain type Oregon 21LP
Other approved bar and chain combinations
in Operator's Manual.
Measured maximum kickback value with
brake for the bar and chain combination on
the label.
Measured maximum kickback value without
triggering the brake, for the bar and chain
combination on the label.
Other symbols/decals on the mac hine refer to special
certification requirements for certain markets.
2 –
Canadian
KEY T O SYMBOLS
Symbols in the operator' s manual:
Switch off the engine b y moving the stop
switch to the STOP position before carrying
out any checks or maintenance.
Always wear approved protective gloves.
Regular cleaning is required.
Visual check.
Protective goggles or a visor must be worn.
Refuelling.
Filing with oil and adjusting oil flow.
The chain brake should be activated when
starting.
Y ou will find the following labels on your chain saw:
EPA I
EPA PH 1