Complete Installation - IKEA W10806909C Instructions D'installation

Option D: No waste disposer –
with air gap
Screw-type clamps
Waste tee
Drain trap
1. Connect rubber end of drain hose
1
to air gap and cut if needed.
NOTE: Do not cut ribbed section.
Rubber
end
2. Attach drain hose to air gap with large
2
drain hose clamp (provided). Use pliers
to squeeze clamp open and move into
position. If the drain hose was cut, use a
1 / " to 2" (38 mm to 50 mm) screw-type
1
2
clamp (not provided).
3. Use a rubber hose (not provided) with
3
screw-type clamps (not provided) to
connect from waste tee to air gap.
24
Air gap
Large drain
hose clamp
Rubber hose
connector
Drain hose

COMPLETE INSTALLATION

Check that the power supply wire or cord does not touch
dishwasher motor or the lower part of the dishwasher tub.
58.
Power supply cord – Plug into a
grounded 3 prong outlet.
Plug into a grounded 3 prong outlet.
59.
Reconnect power
Reconnect electrical power at the fuse box or circuit
breaker box.
NOTE: With the access panel off, start the dishwasher and
allow it to complete the shortest wash cycle. After the first
2 minutes, unlatch door, wait 5 seconds, then open door.
Check that there is water in the bottom of the dishwasher
tub. Check that dishwasher is working properly.