IKEA W10806909C Instructions D'installation page 12

11.
Measure cabinet opening
Measure height of cabinet opening from underside of
countertop to floor where dishwasher will be installed.
Be sure to measure the lowest point on the underside
of the countertop and the highest point on the floor.
Dishwasher Height Adjustment Chart
Cabinet opening Front legs
height
33 / " (851 mm) /
1 3
2 8
34" (864 mm) 7 /
8
34 1 / " (876 mm) 1 1 /
2 8
Front legs – A
Rear legs – B
Adjust both front and back leveling legs to the same height.
12
Rear legs
height A height B
" (9.8 mm) Remove legs
and spacers.
" (22 mm) 1" (25.4 mm)
" (28.8 mm) 1 1 / " (31.3 mm)
4
B
NOTE: If the minimum cabinet opening height is less than 33
(860 mm), the rear leveling legs and spacers can be removed for
additional clearance. This will allow the dishwasher to fit into a
33 1 / " (851 mm) high cabinet opening, but the dishwasher will
2
be more difficult to move. (Measurements are approximate.
Rear and front leveling legs are preset at the factory for 34
[876 mm].)
12.
Adjust leveing legs
Refer to the "Dishwasher Height Adjustment Chart" for height
of leveling legs needed for your cabinet opening.
13.
Remove plastic rail cover
(only on certain models)
Plastic rail cover
Remove and discard the plastic rail cover on each side of
the dishwasher frame. To remove the plastic rail cover, push
upward and back to unsnap it from the dishwasher frame.
/ "
7
8
1 / "
2