JUKI MF-7200D/UT42 Manuel D'utilisation page 47

(4) Setting procedure of the machine head
(Caution) For the operation panel other than CP-18, refer to the Instruction Manual for the operation panel to be
used for the setting procedure of the machine head.
3 4
3 4
3 4
5
6
5 6
5
6
– 6 –
1) Call functon settng No. 95.
2) The type of machne head can be se-
lected by pressng
swtch 6 ).
* Refer to the "Lst of machne heads"
on the separate sheet or the Instruc-
ton Manual for the machne head of
your sewng machne for the type of
the machne head.
3) After selectng the type of machne
head, by pressng
swtch 4 ), the step proceeds to
96 or 94, and the dsplay automatcally
changes to the contents of the settng
correspondng wth the type of ma-
chne head.
swtch 5 (
swtch 3 (