Introduction; Layout; Scope Of Delivery; Intended Use - Scheppach HL1500TWIN Manuel

1. Introduction

MANUFACTURER:
scheppach
Fabrikation von Holzbearbeitungsmaschine GmbH
Günzburger Straße 69
D-89335 Ichenhausen
DEAR CUSTOMER,
We hope your new tool brings you much enjoyment
and success.
NOTE:
According to the applicable product liability laws, the
manufacturer of the device does not assume liability
for damages to the product or damages caused by
the product that occurs due to:
• Improper handling,
• Non-compliance of the operating instructions,
• Repairs by third parties, not by authorized service
technicians,
• Installation and replacement of non-original spare
parts,
• Application other than specified,
• A breakdown of the electrical system that occurs
due to the non-compliance of the electric regu-
lations and VDE regulations 0100, DIN 57113 /
VDE0113.
m Important! We recommend:
Read through the complete text in the operating in-
structions before installing and commissioning the
device. The operating instructions are intended to
help the user to become familiar with the machine
and take advantage of its application possibilities in
accordance with the recommendations. The operat-
ing instructions contain important information on how
to operate the machine safely, professionally and
economically, how to avoid danger, costly repairs, re-
duce downtimes and how to increase reliability and
service life of the machine.
In addition to the safety regulations in the operating
instructions, you have to meet the applicable regula-
tions that apply for the operation of the machine in
your country. Keep the operating instructions pack-
age with the machine at all times and store it in a
plastic cover to protect it from dirt and moisture.
Read the instruction manual each time before op-
erating the machine and carefully follow its informa-
tion. The machine can only be operated by persons
who were instructed concerning the operation of the
machine and who are informed about the associated
dangers. The minimum age requirement must be
complied with.
We assume no liability for accidents or damages
resulting by disregarding these instructions and the
safety instructions.
20 GB
All manuals and user guides at all-guides.com
2. Layout (Fig. 1)
1 Switch/outlet
Electrical motor
2
3 Steel frame
Splitting column
4
5 Hoisting adjustment bar
Splitting wedge
6
7 On/off lever for splitting wedge
Grip protection
8
Rubber stopper
9
10 Fixed splitting table
Lower pivoting table
11
12 Upper pivoting table
Locking hooks
13
14 Splitting wedge extension
Wheels for brief transport
15
16 Transportation handles
Hydraulic oil tank
17
Supporting wheels
18

3. Scope of delivery

• Open the packaging and remove the device care-
fully.
• Remove the packaging material as well as the
packaging and transport bracing (if available).
• Check that the delivery is complete.
• Check the device and accessory parts for trans-
port damage.
• If possible, store the packaging until the warranty
period has expired.
ATTENTION
The device and packaging materials are not toys!
Children must not be allowed to play with plas-
tic bags, film and small parts! There is a risk of
swallowing and suffocation!
• Hydraulic log splitter
• Accessory pack
• Operating arms
• Supporting wheels
• Operating instructions

4. Intended use

The wood splitter has only been designed to split
wood in the fibre direction. Respecting technical data
and safety precautions. When splitting, it is essen-
tial to make sure the split wood only contacts the
checkered sheet of the bottom plate or the checkered
sheet of the splitting desk.
The hydraulic log splitter can only be used in a verti-
cal position. Logs may only be split along the direc-
tion of the fiber. Log dimensions are:
Log lengths 60 cm/ 96,5 cm/ 133 cm
Ø min. 12 cm, max. 40 cm
Never split logs in horizontal position or against
the direction of the fiber.