Hilti PD-I Notice D'utilisation Originale page 15

6.2.2.1 Measuring wall areas (decorator function)
1. Aim the laser at a target point for the room length.
2. Press the
button.
▶ The initial value appears in the top row.
3. Add or subtract measured values. → page 10
4. Repeat steps 1 to 3 until you have measured all the wall lengths.
5. Aim the laser at a target point for the room height.
6. Press the
button.
▶ Measurement has been completed.
The following values are shown on the display:
• Room perimeter
• Room height
• Wall area (decorator area)
6.2.3 Measuring volume
1. Aim the laser at a target point for the room length.
2. Press the
button.
3. Aim the laser at a target point for the room width.
4. Press the
button.
5. Aim the laser at a target point for the room height.
6. Press the
button.
▶ Measurement has been completed.
The following values are shown on the display:
• Room width
• Room height
• Calculated volume
Press button
6.2.4 Measure Pythagoras (2-point)
1. Aim the laser at the first target point.
2. Press the
button.
3. Aim the laser as the second target point at right angles to the target distance.
You can improve the result by activating the "Min/Max" function.
Press the button and hold it down for 2 seconds to activate.
Measure the wall vertically until the length has been measured at exactly a right angle.
4. Press the
button.
▶ Measurement has been completed.
The following values are shown on the display:
• Measured lengths
• Calculated result
6.2.5 Measure Pythagoras (3-point)
1. Aim the laser at the first target point.
2. Press the
button.
3. Aim the laser as the second target point at right angles to the target distance.
You can improve the result by activating the "Min/Max" function.
Press the button and hold it down for 2 seconds to activate.
Measure the wall vertically until the length has been measured at exactly a right angle.
4. Press the
button.
*2222191*
7
and hold it down for 2 seconds to view the room perimeter and the wall area.
8
9
2222191
11
English 9