Trix MINITRIX Kof II Mode D'emploi page 6

Functions
• Built-in electronic circuit for oberation with an
conventional DC power pack, Trix Selectrix or
NMRA DCC digital.
• Automatic system recognition between
digital and analog operation.
• No automatic system recognition between
Selectrix (SX) and DCC.
• Maintenance-free, high-efficiency can motor
with bell-shaped armature.
• Headlights that change over with the direc-
tion of travel.
• Analog 14 volts DC, digital 22 volts AC.
Notes on digital operation:
• The first time the locomotive is used in a
digital system (Selectrix or DCC), the decoder
must be set for this digital system. To do this,
the decoder must be programmed once in this
digital system.
• The operating instructions for your central unit
will give you exact procedures for setting the
different parameters.
• The values set at the factory have been
selected to insure trouble-free operation.
• This locomotive comes from the factory
programmed for the digital address „01"
(Selectrix) / „03" (DCC).
6
• This locomotive with the settings made at
the factory cannot be operated with opposed
polarity DC power in braking track blocks.
If this feature is desired, then you must do
without conventional DC operation (CV 29 /
bit 2=0).
Safety Warnings
• Pay close attention to the safty warnings in
the instructions for your operating system.
• Always increase the track voltage slowly
and evenly.
• In DC operation the locomotive's running
characteristics depend on the speed cont-
roller you are using.
• Not suitable for locomotive controllers with
pulse width control.
• Not suitable for continuous train lighting on
analog layouts.
• Not suitable for Trix ems.
No warranty or damage claims shall be accepted in
those cases where parts neither manufactured nor
approved by Trix have been installed in Trix products
or where Trix products have been converted in such
a way that the non-Trix parts or the conversion were
causal to the defects and/or damage arising. The
burden of presenting evidence and the burden of proof
thereof, that the installation of non-Trix parts or the
conversion in or of Trix products was not causal to the
defects and/or damage arising, is borne by the person
and/or company responsible for the installation and/or
conversion, or by the customer.