Installation Instructions; Built-In Refreshment Center - KitchenAid KFFU271 Guide D'utilisation

Warming Drawer Size
24" (61.0 cm)
*Dimension L is the minimum mounting surface area around the opening for mounting the optional door or drawers.
WARNING
Excessive Weight Hazard
Use two or more people to move and install
refreshment center.
Failure to do so can result in back or other injury.
Use a certified plumber to connect and install potable water
supply and drain system to outdoor refreshment center
according to local code requirements.
1. Using two or more people, set the refreshment center on a
covered surface.
2. Install rear flange to back of built-in refreshment center using
4 mounting screws provided.
A. Rear flange
3. Check that you have the drain connections, in accordance
with local codes, under the refreshment center.
4. Remove the faucet from the ice bin.
6
Cutout Dimensions - Built-in Warming Drawer
Dimension J
22½" (57.2 cm)
Cutout Dimensions - Built-in Utility Drawer and Built-in Trash Drawer
Dimension M
12¼" (31.1 cm)

INSTALLATION INSTRUCTIONS

Built-In Refreshment Center

A
Dimension L*
1½" (3.8 cm)
5. Install the faucet and fasten securely.
A
B
E
A. Faucet
B. Brass escutcheon with "O" ring
C. Sink
D. Plastic washer
E. Locking nut
6. Install water inlet connector in a convenient location under
the cutout. Position the water inlet connector so that the
plastic tubing easily reaches the filter inlet connection.
A
A. Plastic tubing from water filter
(inlet)
B. Hose connector
C. Hose connector nut
7. Connect ice bin drain and sink drain fittings to drain system in
accordance with local code requirements.
C
D
C
B
D
E
F
D. Brass locking nut
E. Inlet connector (¾" MHT x ½"
MIP hose adapter)
F. Exterior side of mounting panel