Changing Fuses - Idexx Quanti-Tray Sealer PLUS Mode D'emploi

4. Close the sealer:
a) Lift the lever slightly to release the upper access door assembly. The upper access
door returns to the closed position.
b) Fully slide the lower access panel back into the sealer until it clips into place.
Note: You may need to lift up on the metal insert platform while sliding
the lower access panel into place.
c) Use a standard flathead screwdriver to lock the panel,
turning the screw 90° counterclockwise.
Do not overtighten the latch.

Changing Fuses

Fuses are located in the fuse holder beside the power switch.
If you need to change a fuse, turn off the sealer and unplug the power cord before opening the fuse box.
Use two 10 A, 5 x 20 mm, time-lag fuses. Designed to IEC or local requirements.
8
4a.
4b.
4c.