Drip Stop Function; Cleaning And Maintenance; Cleaning After Every Use; Cleaning The Coffee Bean Chute - Philips HD7740 Mode D'emploi

3 Close the filter basket holder and place the jug on the hotplate.
4 Follow steps 8-10 in section 'Using coffee beans'.

Drip stop function

The drip stop function enables you to remove the jug from the
coffeemaker before the brewing process is finished. When you remove
the jug, the drip stop stops the flow of coffee into the jug.
Note: The brewing process does not stop when you remove the jug. If you
do not put the jug back onto the hotplate within 20 seconds, the filter
basket overflows.
Note: Make sure the jug lid is in place when you put the jug back onto the
hotplate. Without the jug lid, the drip stop function is activated automatically.

cleaning and maintenance

cleaning after every use

Never immerse the appliance in water or any other liquid, nor rinse it
under the tap.
1 Press the START/STOP button to switch off the coffeemaker and
remove the plug from the wall socket.
2 Wipe the outside of the coffeemaker and the hotplate with a damp
cloth.
3 Clean the filter basket, the permanent filter and the jug with hot
water and some washing-up liquid.

cleaning the coffee bean chute

You have to clean the coffee bean chute every 1 to 2 weeks, depending on
the frequency of use.
1 Press the START/STOP button to switch on the coffeemaker and
remove the plug from the wall socket.
Note: By pressing the START/STOP BUTTON, the valve in the coffee bean
chute remains open when you unplug the appliance. This is necessary for
cleaning.
2 Insert the flat end of the cleaning brush handle into the chute lock
and turn the lock to the 'open' position.
3 Open the lid of the coffee bean chute.
EnglisH
11