Using Pre-Ground Coffee; Setting The Timer; Drip Stop Function - Philips Grind&Brew HD7762 Mode D'emploi

Tip:
E
We advise you to experiment with
the amount of water to find out which
strength you prefer. If you select a number
of cups that is higher than the amount of
water, the coffee becomes stronger. If you
select a number of cups that is smaller
than the amount of water, the coffee
becomes weaker.
Press in the centre of the knob to confirm,
14
Then press in the centre of the knob again to
start the brewing process (Fig. 19).
• The grinder grinds the required amount of
coffee beans.
Wait until the coffeemaker has stopped
15
brewing before you remove the jug.
Note:
D
After brewing, coffee drips from the filter
basket for several seconds.

5.3 Using pre-ground coffee

If you want to use pre-ground coffee instead of
coffee beans, follow the steps below.
Open the water reservoir lid and fill the water
1
reservoir with the required amount of cold
water. (Fig. 6)
To open the filter basket holder, pull at its tab
2
on the right side of the coffeemaker (Fig. 14).
Take a paper filter (type 1x4 or no. 4) and
3
fold the sealed edges to prevent tearing and
folding. Place the paper filter in the filter
basket (Fig. 15).
Put pre-ground coffee in the paper filter.
4
Note:
D
You can adjust the strength of the coffee to
your own personal taste. For a medium-strong
cup of coffee, use one measuring spoon
(approximately 6g) of ground coffee for each
cup (120ml). For stronger coffee,
use 1.5 measuring spoons of ground coffee
for each cup of coffee.
Close the filter basket holder.
5
Put the jug in the appliance (Fig. 7).
6
Press the on/off button (Fig. 8).
7
• The display lights up.
Press the strength select button (Fig. 9).
8
Turn the knob to choose the pre-ground
9
coffee setting (Fig. 10).
• The pre-ground coffee icon lights up.
Press in the centre of the knob to confirm.
10
Then press in the centre of the knob again to
start the brewing process (Fig. 11).
Wait until the coffeemaker has stopped
11
brewing before you remove the jug.
Note:
D
After brewing, coffee drips from the filter
basket for several seconds.

5.4 Setting the timer

The timer enables you to program the time at
which you want the brewing process to start.
Make sure all steps of brewing coffee are taken
with either preground or coffee beans before
setting the timer.
Press the timer button. (Fig. 20)
1
• On the display 00:00 flashes to indicate
that you have to set the timer.
Turn the knob to set the hour (Fig. 21).
2
Press in the centre of the knob to confirm the
3
hour (Fig. 22).
• The minutes starts to flash to indicate that
you have to set the minutes.
Turn the knob to set the minutes (Fig. 23).
4
Press in the centre of the knob to confirm the
5
minutes (Fig. 24).
The timer is set and the brewing process will
•
start at the preset time.

5.5 Drip stop function

The drip stop function enables you to remove
the jug from the coffeemaker before the brewing
process is finished. When you remove the jug, the
drip stop stops the flow of coffee into the jug.
Note:
D
The brewing process does not stop when you
remove the jug. If you do not put the jug back
into the appliance within 20 seconds, the filter
basket overflows.
9