Drip Stop Function - Philips HD5405 Mode D'emploi

EnglisH
8
Tip: When the brewing process is finished, you can pour the hot coffee into a thermos jug to keep it hot
and fresh.

Drip stop function

The drip stop function enables you to remove the jug from the coffeemaker before the brewing
process is finished. When you remove the jug, the drip stop stops the flow of coffee into the jug.
Note: The brewing process does not stop when you remove the jug. Place back the jug as soon as possible
to prevent overflowing.
Note: Make sure the jug lid is in place when you put the jug back onto the hotplate. Without the jug lid,
the drip stop function is activated automatically.
after drinking coffee
1 Open the filter holder support (Fig. 12).
2 Lift the filter holder with the paper filter out of the filter holder support (Fig. 13).
3 Throw away the used paper filter with the coffee grounds (Fig. 14).
4 Switch off the appliance. (Fig. 15)
making another jug of fresh coffee right away
If you want to make another jug of fresh coffee right away, switch off the appliance and let it cool
down for three minutes. Fill the water tank with cold water again and put a new amount of ground
coffee in a new paper filter. Now you can make fresh coffee again.
Note: If you do not let the appliance cool down for three minutes before you brew coffee again,
water starts dripping into the filter holder right away.
- Make sure you pour the first amount of fresh water against the temperature sensor in the
centre of the cover (Fig. 16).
When you do this, the outflow opening in the bottom of the water tank closes again.
cleaning
Never immerse the appliance in water or any other liquid.
Never use scouring pads, abrasive cleaning agents or aggressive liquids such as petrol or acetone
to clean the appliance.
1 Switch off and unplug the appliance.
2 Clean the outside of the appliance with a moist cloth.
3 Clean the detachable parts in hot water with some washing-up liquid or in the dishwasher.
4 Clean the rubber insert in the outflow opening of the water tank every month and after
every descaling procedure (Fig. 17).
Do not forget to put the insert back into place before you use the appliance again.
Never remove the rubber insert if there is still hot water in the water tank.