Bosch 4310 Consignes De Fonctionnement/Sécurité page 20

BM 2610012089 03-10 E:BM 2610012089 03-10 E 3/30/10 7:41 AM Page 20
Mounting the Saw
portable Mounting Using Clamps
• If necessary, clamp the miter saw to a workbench
or table top.
• Place two (2) or more "C" clamps on the clamping
areas and secure (Figure 17).
• Be careful not to place clamps over the base
extension clamping levers (Figure 17).
• Mounting with clamps will prevent access to some
wide miter angles.
Adjusting the four position Switch Handle (Model 4410 only)
Setting Main Handle in Desired position
The switch handle can be positioned in any of four
different orientations, depending on the cutting
situation and user preference.
a. Vertical b. 45° Left c. Horizontal d. 45° Right
To reposition the main handle:
1. Release handle clamp (Figure 18).
2. Pull and hold handle rotation release lever
(Figure 18).
3. Rotate handle to desired location.
4. Let go over release lever to set handle into
place. Release lever will retract down only in
one of the four (4) positions
Handle lock
Clamp
Handle
Rotation
Release
a.
All manuals and user guides at all-guides.com
Transporting, placement and Mounting
lever
b.
figure 18. Setting Main Handle position
Clamping
Areas
Clamping Areas
figure 17. portable Mounting Using Clamps
Note: Power switch can not be actuated unless re-
lease lever is retracted down. Do not attempt to
switch tool on between handle position, damage
may occur.
5. Lock the handle clamp.
Adjusting the four-position Handle
lock Clamp Tension
1. Open handle clamp.
2. Using 1.5 mm Allen wrench, increase tension by
turning both setscrews 1/4 turn to the left, tighten
by turning to the right. Always adjust both
setscrews by the same amount.
3. Close handle clamp.
4. Check the tension.
c.
-20-
d.