Assembling Dust Elbow And Dust Bag - Bosch 4310 Consignes De Fonctionnement/Sécurité

Table des Matières

Les langues disponibles

BM 2610012089 03-10 E:BM 2610012089 03-10 E 3/30/10 7:40 AM Page 12

1. With the miter arm locked in the down position,

push the dust elbow onto the dust port. Push the

dust bag onto the elbow and rotate both to de-

sired position. (Figure 4).

2. Position dust chute/bag so that it does not inter-

fere with the tool during the cutting operation for

all miter/bevel settings. Make sure dust bag does

not interfere with the slide rails during slide cut-

ting.

3. The dust bag requires emptying when full of

sawdust. Empty it frequently and after completion

of sawing. Carefully remove dust bag from dust

elbow.

Empty dust bag in proper trash

bin by unzipping the bag. Be extremely careful of

dust disposed, materials in fine particle form may

be explosive. Do not throw sawdust on an open-

fire. Spontaneous combustion, may in time, result

from mixture of oil or water with dust particles.

NOTE: The dust port accepts the Bosch VAC004

Vacuum Hose Adapter, which allows connection to

a Bosch 35mm vacuum hose.

Attaching Miter lock Knob

Locate the miter gauge lock knob from among the

loose parts, and thread shaft on lock knob into hole

provided.

Attaching Rear Cord Wrap

Locate the rear cord wrap from among the loose

parts, position rear cord wrap as shown and secure

with washer and phillips screw provided.

All manuals and user guides at all-guides.com

Assembly