Unpacking And Checking Contents - Bosch 4310 Consignes De Fonctionnement/Sécurité

BM 2610012089 03-10 E:BM 2610012089 03-10 E 3/30/10 7:40 AM Page 10
Combination Square
Draw Light
Line on Board
Along this Edge
Should be no Gap or Overlap
when Square is Flipped Over
in Dotted Position
Disconnect plug from power source before performing any assembly, adjustment or repair
W RNING
to avoid possible injury.
Before moving the saw: Lock the
W RNING
miter lock knob in 45° position.
Lock bevel lock handle. Pull the head assembly com-
pletely toward you and tighten the slide rail lock knob.
Lock head assembly in the down position.
Never carry the tool by the slide rails, this may
cause blade damage.
Never carry the tool by the cord or head assembly
power switch handle. Damage to insulation could
cause an electric shock. Damage to wire connec-
tions could cause a fire.
Models 4310 & 4410 Miter Saws are shipped complete
in one box.
1. Separate all parts from packing materials and
check each one with the "Table of Loose Parts" to
make sure all items are accounted for before
discarding any packing material.
2. Table of Loose Parts:
Quick- Action Clamp (Model 4410 only) - Used to
clamp workpieces.
Workpiece Clamp (Model 4310 only) - Used to
clamp workpieces.
Dust Elbow/Dust Bag - Used to collect saw dust.
(Multi purpose tool model 4410) or multi purpose
"L" wrench model 4310) - Should be stored on
the right rear base.
All manuals and user guides at all-guides.com
Assembly
Tools Needed for Assembly And Alignment
Hex "L" Wrench
(supplied) 1.5mm
Combination Square Must be True
Straight Edge of Board 3/4"
Thick This Edge Must be
Perfectly Straight

Unpacking And Checking Contents

Multi Purpose "L" Wrench 6.5mm
(supplied with model 4310 only)
10mm/17mm Combination
Rear Cord Wrap, washer and Screw - Used for
wrapping the cord
Miter Lock Knob - Used to lock the table at de
sired miter angle.
If any parts are missing, do not
W RNING
plug in power cord or turn the
switch on until the missing parts are obtained and
are installed correctly.
Rear Cover Tool Storage
The Open End Wrench and Hex Wrenches are
stored on the inside rear cover of the saw. To re-
move the cover, unscrew the two top and center
thumb screws.
Thumb
Screws
-10-
Multi Purpose Tool (supplied
with model 4410 only)
Open End Wrench