Connecting To Video Devices - JVC D-ILA DLA-G150CLU Manuel D'instructions

DLA-G150CLU&CLE_Eng.book Page 24 Thursday, February 21, 2002 2:39 PM
Connecting to Various Devices

Connecting to Video Devices

Before connection, be sure to turn off both the projector and video device.
• Read thoroughly the manual that comes with each video device.
• Use the supplied video cable. An video cable with an S-video (Y/C) terminal is not supplied.
IN
Notes
• Connect a composite image signal output device or Y/C (S-video) image output device.
• When connecting the S-video cable, refer to "How to attach the ferrite core" on page 29.
Memo
• When connecting a video device, use a TBC along with it, or one which has a built-in TBC.
• Use of an extension cable to connect a video device and the projector could cause video degradation.
• When a signal with much jitter is reproduced on a VCR, or special-effect playback is performed, the upper part of the image
or the image itself may be erased or distorted.
24
R
Y
Y/C
BNC-RCA conversion
plug (accessory)
G
P /B-Y
B
VIDEO
B P /R-Y
R
REMOTE
H
V
IN OUT
Video devices
• VCR (Video cassette recorder)
• Laser videodisc player
• Camcorder
DLA-G150CLU / LCT1123-001B / ENGLISH
To AV IN
S-video cable
(separately available)
Video cable
(accessory)