Changing The Color System (Video Menu Mode Only) - JVC D-ILA DLA-G150CLU Manuel D'instructions

DLA-G150CLU&CLE_Eng.book Page 45 Thursday, February 21, 2002 2:39 PM

Changing the Color System (Video Menu Mode Only)

This function is available only in Video menu mode.
The menu is only displayed when there is a signal for the AV IN (Y/C, VIDEO and COMP) terminal.
Normally, use the color system in AUTO. If operation in AUTO is unstable, such as color not being shown, set to a dedicated
color system in accordance with the color system of the video signal being input.
1
Press the MENU button.
The main menu appears on the screen.
2 Select "Set up" with the cursor button 5 or ∞ ∞ ∞ ∞ , and press 3 3 3 3 or the ENTER button.
The "Set up 1" submenu appears on the screen.
3 Select "Decoder" with the cursor button 5 or ∞ ∞ ∞ ∞ , and press the ENTER button.
The "Decoder" submenu appears on the screen.
Video submenus
Position
Gamma
Aspect ratio
Decoder
Page 2
4
Set the color system with the cursor button 5 or ∞ ∞ ∞ ∞ .
AUTO: Normally, set to "AUTO". (Factory set value)
The color system of a video signal being input is automatically identified and displayed in [ ].
In [ ], B/W (Black & White), NTSC, NTSC4.43, PAL or SECAM will be displayed. (It is not always displayed.)
For example, AUTO [ NTSC ] shows that the NTSC signal is being received.
NTSC: Dedicated to NTSC.
NTSC4.43:Dedicated to NTSC4.43.
PAL: Dedicated to PAL.
SECAM: Dedicated to SECAM.
5
Press the EXIT button to return to the previous menu or press the MENU button to
exit the menu mode.
Set up 1
ENTER
Down Cinema Up
4:3 16:9
ENTER
ENTER
DLA-G150CLU / LCT1123-001B / ENGLISH
Decoder
AUTO [ NTSC ]
NTSC
NTSC4.43
ENTER
PAL
SECAM
EXIT
Menu Operations
45