5.2 Operation
Prior to first use
CAUTION!
Never fill hot water into the cold water tank.
Do not fill water into the hot device; wait until it has cooled down.
•
Prior to first use it is necessary to run 2 or 3 cycles of water through the machine
without coffee, in order to properly rinse the unit („Preparation of coffee" steps 1-8).
•
Due to the nature of the system a small amount of water always remains in the container
for water. It is necessary to take this into account when refilling the container.
•
Always fill the water container with an
amount of water equal to the capacity
of the thermo pump jug included with
the coffee machine. The amount of
coffee brewed will be the same as the
amount of water poured.
•
If too much water is poured into the
water container, excess water will
drain out through the flow hose.
•
The thermo jug and filter basket with insert should be thoroughly washed in warm
water and a mild cleaning agent, then rinsed in clean water. Dry thoroughly after
washing.
CAUTION!
When cleaning, be aware of the remo-
vable insert at the bottom of the filter
basket. After cleaning, replace the insert
in the filter basket so that it is secured to
the bottom of the filter and will not be
accidentally thrown out while disposing
of coffee grounds.
When brewing coffee without the insert,
the paper filter can block the filter basket's
drip flow opening and hinder the flow of
coffee to the thermo jug.
•
The unit's casing should be wiped with a moist cloth and dried with a soft towel.
- 30 -
Flow hose
Insert
Filter basket