Break-In Period; Using The Pressure Washer - Power Fist 8913212 Mode D'emploi

V1.1
NOTICE! DO NOT siphon standing water for the water supply. Particulate
matter can contaminate the pump. Use only clean, cold water (less than
100°F).
NOTICE! DO NOT run the pump without the water supply connected and
turned on. This may damage the pump mechanism beyond repair.
When the engine is running, do not allow the Pressure Washer to remain
idle for more than two minutes. If allowed to remain idle, the water in the
unit will heat up, possibly causing damage to the Pressure Washer.
During normal operation the thermal relief valve may release small amounts of
water intermittently.
1. Turn on the water spigot.
2. Squeeze the trigger for one minute to purge air from the system. Reset
the trigger guard.
3. Start the engine by following the instructions in the engine manual.

BREAK-IN PERIOD

Breaking-in the engine will help to ensure proper equipment and engine
operation. The operational break-in period will last about 3 hours of use.
During this period:
1. Do not apply a heavy load to the equipment.
2. Do not operate the engine at its maximum speed.
The maintenance break-in period will last about 20 hours of use. Change the
engine oil after this period.

USING THE PRESSURE WASHER

1. Unlock and hold down the trigger to start the stream. Be aware that
when it is first started, the gun will kick.
2. Start with a low pressure nozzle and gradually use higher pressures as
needed.
a. Test spray the surface at an edge to make sure that the stream is
not too strong.
b. If the stream damages the surface, move farther away to reduce
the applied pressure.
c. If the stream is still too strong, lock the trigger in the safety
position and change to a lower pressure nozzle.
Visit www.princessauto.com for more information
Gas Pressure Washer 8913212
11