Power Fist 8913212 Mode D'emploi page 13

V1.1
The high pressure hose can develop leaks due to wear, kinking or misuse and
abuse. Inspect the hose each time before using it. Check the hose for cuts,
leaks, abrasions or bulging spots. Also check the couplings to ensure they are
not loose. Replace the hose immediately if any of these conditions exist.
CHECK SIPHON TUBE
Check the detergent siphoning tube for clogs, leaks or tears. Clean the tube of
clogs. Replace if damaged or it no longer fits the pump fitting tightly.
CHECK SPRAY GUN
Examine the hose connection to the spray gun and make sure it is secure. Check
that the trigger lock is in place to prevent accidental spraying. Replace the spray
gun immediately if the trigger lock is damaged or will not remain in place.
CHECK SPRAY WAND AND PRESSURE NOZZLES
A pulsing sensation felt when squeezing the trigger indicates either the
spray wand or the pressure nozzle is partially clogged and is causing
pressure to build in the pump.
1. Shut off the engine and turn off the water supply. Then release the
pressure in the pump system by aiming the spray gun in a safe
direction and squeezing the trigger.
2. Remove the spray nozzle from end of spray gun wand.
3. Use a small paper clip to free any foreign material clogging or
restricting the spray nozzle.
4. Disconnect the spray gun wand and check for foreign material that
may clog the tube.
5. Remove additional debris by back flushing water through the spray
gun wand using a garden hose.
6. Reinstall spray nozzle into spray gun wand.
7. Reconnect spray gun wand to spray gun.
8. Make sure the garden hose is connected to the pump' s water inlet.
Check that high pressure hose is connected to spray gun and pump.
Turn on the water.
9. Start engine following instructions Starting Your Pressure Washer
10. Test the pressure washer with each of the five spray nozzles to ensure
they are all unclogged.
Visit www.princessauto.com for more information
Gas Pressure Washer 8913212
13