Lubrication - Power Fist 8913212 Mode D'emploi

8913212
REPAIRING LEAKING CONNECTIONS
WARNING! Do not use thread-seal tape or liquid to prevent leaks in the
high pressure hose. This can cause a high pressure leak that can result
in a serious injury or injection injury.
1. Replace the o-rings of any connection that leaks.
2. Replace the connectors if the leaks continue.
EMPTY THE PUMP
Force water from the pump by pulling the recoil starter 6 times.
ENGINE MAINTENANCE
See the Engine manual for instructions on how to properly maintain the engine.
CLEANING
Use a damp cloth to wipe exterior surfaces clean. A soft bristle brush can
loosen caked on dirt, oil, etc. A vacuum cleaner will remove loose dirt and
debris in difficult to reach places.
Examine the screen on the pump water inlet. Clean it if the screen is
clogged or replace it if screen is damaged.
MAINTENANCE SCHEDULE
After Each Use
Annually (50 hours of use)

LUBRICATION

Inspect and lubricate the tool when required. Only use light oil to lubricate
the tool. Other lubricants may not be suitable and could damage the tool or
cause a malfunction during use.
14
Gas Pressure Washer
Check and Clean Water Inlet screen
Check High Pressure Hose
Check and Clean Detergent Siphoning Tube
Check Spray Gun for Leaks
Clean Debris
Check Engine Oil Level before starting
Check and Clean Air Filter
Check muffler and spark arrester
For technical questions call 1-800-665-8685
V1.1
Table 2