Shutting Down; Taking A Break - Power Fist 8458804 Manuel D'utilisateur

V 3.0

SHUTTING DOWN

1. Turn the switch to OFF (0) position and unplug power cord (#2) from outlet.
2. Turn off the water supply.
3. Squeeze trigger for 20-30 seconds to de-pressurize the system.
4. Disconnect the garden hose from the water inlet on the unit.
5. Disconnect the high-pressure hose from the water outlet (#1) and engage the trigger lock (#9).

TAKING A BREAK

1. Engage trigger lock (#9).
2. Turn pressure washer to OFF (0) position.
3. Unplug the power cord (#2) from the outlet.
WASHING BEST PRACTICES
1. Before cleaning any surface, start with an inconspicuous area to test spray pattern and distance for
maximum cleaning results.
2. Pre-rinse cleaning surface with fresh water.
3. If using detergent or degreaser, apply to surface at low pressure. Allow detergent to remain on
surface 1 to 3 minutes.
4. Do not allow detergent to dry on surface. If surface appears to be drying, simply wet down surface
with fresh water.
5. Always apply detergent from bottom to top.
6. Rinse at high pressure in a sweeping motion, keeping the spray nozzle approximately 3 to 6 inches from the
cleaning surface.
7. Always rinse from top to bottom and from left to right.
MAINTENANCE
1. Maintain the tool with care. A tool in good condition is efficient, easier to control and will
have fewer problems.
2. Inspect the tool components periodically. Repair or replace damaged or worn components.
3. Follow instructions for lubricating and changing accessories.
4. Keep the tool handles clean, dry and free from oil/grease at all times.
CAUTION! Only qualified service personnel should repair the tool.
6
1.6 GPM @ 1,740 PSI Electric Pressure Washer 8458804
For technical questions call 1-800-665-8685