Power Fist 8913212 Mode D'emploi page 16

8913212
6. Remove the pump saver container and plug the pump' s inlet and outlet.
RV ANTIFREEZE
RV antifreeze is an alternative if pump saver is not available.
1. Obtain a funnel, six ounces of RV (Recreational Vehicle) antifreeze and
approximately 36 inches of garden hose with a male hose connector on
one end.
NOTICE! Only RV antifreeze is suitable. Other types of antifreeze are
corrosive and can damage the pressure pump.
2. Disconnect the spark plug lead and ensure it cannot touch any metal on
the pressure washer by wrapping the lead in insulating tape.
3. Connect the 36 in. length of garden hose to the pump' s water inlet.
4. Place the funnel in the end of the hose and add the RV antifreeze.
5. Pull engine starter rope slowly several times until antifreeze comes out
of pressure hose connection of the pressure pump.
6. Remove the garden hose from water inlet of pressure pump and seal
the pump' s inlet and outlet.
DISPOSAL
Recycle a tool damaged beyond repair at the appropriate facility.
Contact your local municipality for a list of disposal facilities or by-laws for
electronic devices, batteries, oil or other toxic liquids.
IMPORTANT! DO NOT pollute the environment by allowing uncontrolled
discharge of waste oil.
TROUBLESHOOTING
Visit a Princess Auto Ltd. location for a solution if the tool does not function
properly or parts are missing. If unable to do so, have a qualified technician
service the tool.
Consult the Engine manual to troubleshoot engine issues.
Problem(s)
No pressure or Low
pressure.
16
Gas Pressure Washer
Possible Cause(s)
1. Low water supply.
2. Nozzle obstructed.
3. Water filter screen
obstructed.
Suggested Solution(s)
1. Water supply must be 2.5
GPM @ 20 psi.
2. Clean nozzle of debris.
3. Remove and clean filter.
For technical questions call 1-800-665-8685
V1.1