Using Detergent; Starting The Pressure Washer - Power Fist 8913212 Mode D'emploi

8913212
Black 65°
(Soap)
ATTACH THE WATER HOSE
1. Attach the hose to a water spigot. The water hose muse be 10 ft or
longer with no other connections that will restrict or divert the water
flow.
2. Check the screen in the pump' s water inlet
valve and remove any debris.
3. Run water through hose to flush out debris,
before attaching the end to the inlet below the
high pressure hose (Fig. 7).

USING DETERGENT

IMPORTANT! Only use the Black (Soap) Nozzle when spraying detergents.
The power of the other nozzles will propel mist back at the operator and
can embed detergent into the surface.
1. Read the detergent' s directions. Only use detergents
specified for use with pressure washers.
2. Connect the Detergent Siphon Tube (#25) to the
nipple on the Pressure Hose connection area of the
Pump (Fig. 8).
3. Submerge siphon tube' s strainer end (#26) into
the container of prepared detergent solution.
4. Follow instructions to start the pressure washer.

STARTING THE PRESSURE WASHER

WARNING! The red trigger lock must be in place to prevent accidental
activation of the spray gun. Flip the red lever on the trigger up so it
rests in the depression in the handle. Aim the spray gun in a safe
direction and test the trigger to ensure the lock is working.
10
Gas Pressure Washer
Wet surfaces or apply
chemicals/detergents.
Does not provide
enough force to clean
by itself.
For technical questions call 1-800-665-8685
V1.1
Table 1
Fig. 7
Fig. 8